Edit controls bug and request Register | Edit Profile | Moderators | Log Out
Topics | Last Day | Last Week | Search

AutoDesSys Forums » form•Z Discussion » Archive 2007 » Archive February 2007 » Edit controls bug and request « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

pylon
Member
Username: Pylon

Post Number: 57
Registered: 10-2005


Posted on Monday, February 05, 2007 - 01:03 pm:   Edit Post Print Post

Zweb,

Bug:
Attempting to change the reference plane or the state of the Perpendicular switch while using edit controls on an axial sweep (smooth or facetted) fails. I have not tested the other sweep types to see if they are affected as well.

Request:
Please include 'Add point' and 'delete point' functions when editing the underlying source/path curves of object types that currently allow curve editing only. (e.g., sweeps).

Thanks.
Top of pagePrevious messageNext messageBottom of page Link to this message

pylon
Member
Username: Pylon

Post Number: 58
Registered: 10-2005


Posted on Monday, February 05, 2007 - 01:43 pm:   Edit Post Print Post

Another little problem:

application/octet-stream
sweep_disp_res_prob.fmz (292.1 k)


1. View attached object in openGl shaded.
2. Change display resolution to 10 x 100.
3. View again.
Result: Gap in smooth sweep. Confirm by zooming in in wireframe mode or converting to facetted.

?
Top of pagePrevious messageNext messageBottom of page Link to this message

pylon
Member
Username: Pylon

Post Number: 59
Registered: 10-2005


Posted on Monday, February 05, 2007 - 02:03 pm:   Edit Post Print Post

Here's another one, this one acting up at 10 x 50 facets.



application/x-zip-compressed
sweep_disp_res_prob_2.fmz.zip (220.7 k)
Top of pagePrevious messageNext messageBottom of page Link to this message

support@formZ.com
Moderator
Username: Tech

Post Number: 1509
Registered: 04-2001


Posted on Monday, February 05, 2007 - 02:05 pm:   Edit Post Print Post

Pylon,

Thanks for your reports and suggestion. We will get these corrected and added to our list.

ZWebTech Support