Curving Editable Text? Register | Edit Profile | Moderators | Log Out
Topics | Last Day | Last Week | Search

AutoDesSys Forums » form•Z Discussion » Archive 2007 » Archive February 2007 » Curving Editable Text? « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Chris
New member
Username: Iconik

Post Number: 1
Registered: 02-2007
Posted on Monday, February 12, 2007 - 07:41 pm:   Edit Post Print Post

EDIT - Never Mind... I found the answer!

I'm stumped!

Is there any way that I can curve editable text in FormZ (v5.0.4)?!?

As soon as I use the deform tool, it converts the text to mesh or whatever.

I just wish I could curve some text to the arc I need, then copy it and edit, rather than having to curve every single piece of text individually.

IS THERE AN EASIER WAY?!?!?

(Message edited by iconik on February 12, 2007)
Top of pagePrevious messageNext messageBottom of page Link to this message

support@formZ.com
Moderator
Username: Tech

Post Number: 1562
Registered: 04-2001


Posted on Tuesday, February 13, 2007 - 08:33 am:   Edit Post Print Post

Chris,

As you most likely discovered, you can Place Text on a Line (and that line can be an arc or spline curve if you like).

Also, don't forget to patch from 5.0.4 to 5.0.6...

ZWebTech Support