Some issues Register | Edit Profile | Moderators | Log Out
Topics | Last Day | Last Week | Search

AutoDesSys Forums » form•Z Discussion » Archive 2007 » Archive February 2007 » Some issues « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Craig Williams
Senior Member
Username: Craigwilliams

Post Number: 176
Registered: 04-2001


Posted on Thursday, February 15, 2007 - 09:59 am:   Edit Post Print Post

A couple of issues with 6.1.1.

1. Selecting a face or segment does not highlight the corresponding layer when "HIGHLIGHT SELECTED" is checked in the layer options. Refreshing the palette by minimizing/maximizing fixes it.

2. The scroll wheel doesn't scroll all the way to extents of the layer palette.

3. The scroll wheel seems to skip rows of the surface styles when scrolling through the palette.

Windows XP, service pack 2
Intellimouse Explorer 3.0
Top of pagePrevious messageNext messageBottom of page Link to this message

support@formZ.com
Moderator
Username: Tech

Post Number: 1582
Registered: 04-2001


Posted on Thursday, February 15, 2007 - 10:24 am:   Edit Post Print Post

Craig,

#3 is not a bug because formZ is scrolling based on the settings in your Mouse Control Panel. If you set the Mouse Properties / Wheel to scroll only 1 line at a time, then no rows will be skipped.

#2 stops scrolling when the number you specified in the Mouse Properties / Wheel is greater than the number of Layers that are left. (Obviously we should then just scroll to the bottom...)

Thanks for your reports, we will get these (1 & 2) corrected.

ZWebTech Support
Top of pagePrevious messageNext messageBottom of page Link to this message

Craig Williams
Senior Member
Username: Craigwilliams

Post Number: 178
Registered: 04-2001


Posted on Thursday, February 15, 2007 - 10:41 am:   Edit Post Print Post

Ztech,

Thanks! The control panel I have for the Intellimouse doesn't have an option for One Line at a time (only slow to fast), so I wasn't aware this was the issue. Setting it to the slowest speed fixed the problem.

Craig