Drive a controlled segment from NURBS Register | Edit Profile | Moderators | Log Out
Topics | Last Day | Last Week | Search

AutoDesSys Forums » form•Z Discussion » Archive 2012 » Archive July - Dec 2012 » Drive a controlled segment from NURBS « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Dan
Senior Member
Username: Designd

Post Number: 551
Registered: 05-2001


Posted on Monday, November 05, 2012 - 01:58 pm:   Edit Post Print Post

Previously to FZ 7 I could drive a segment from a NURBS edge and I got a spline with controls that match the controls of the NURBS surface.
Now the same operation results with a plain curve.
How can I extract a matching controlled spline in FZ 7?

Dan
Top of pagePrevious messageNext messageBottom of page Link to this message

Dan
Senior Member
Username: Designd

Post Number: 552
Registered: 05-2001


Posted on Monday, November 05, 2012 - 02:51 pm:   Edit Post Print Post

Forget it. Works fine now.
Top of pagePrevious messageNext messageBottom of page Link to this message

support@formZ.com
Moderator
Username: Tech

Post Number: 18120
Registered: 04-2001


Posted on Monday, November 05, 2012 - 02:53 pm:   Edit Post Print Post

Hi Dan,

If this is an untrimmed NURBS Surface, then you should still be able to derive a segment and maintain the original controls of surface. (Just make sure that you are using the Object Part when trying to Show Controls.)

If this is not working for you, can you post a file that contains the surface so we can look into this further?
Top of pagePrevious messageNext messageBottom of page Link to this message

support@formZ.com
Moderator
Username: Tech

Post Number: 18121
Registered: 04-2001


Posted on Monday, November 05, 2012 - 02:53 pm:   Edit Post Print Post

Aha -- just saw your last post -- great!